Colsed

[Zenator]

Twin Posts please delete.

[Zenator]

To start off with im doing the out side water blocks/res there will be 6 in all three at the top and three at the bottom. All 6 will be part of the cooling loop.

They will be fitted to the out side of the case, The three on top will be linked the one's on the bottom. So one top one will link to one bottom one, with 3x 5mm clear tubes and so on. on the back of each block will be one fitting that go's to a stand 1/2 mantel bent loop. back to one of the other blocks and keeps going. Lets just call the outer blocks (Loop rails.)

So below I have started a quick step by step.
for the blocks, after ill be adding the 3x 5mm tubes to the 2x blocks to make one (Loop Rail.) and this will be done 3 times.











Will add more soon for the Loop rails. Still working hard on the Vector files for the case parts as well. And still working my full time job. Sleep! what is that I ask.:) But I have 10 days off after next week. For more Modding.

Again as always thanks for stopping by.
Cheers, Ken.

[Zenator]

So what I have been going is working on the Motherboard armor and the back plate IO shield that will lock onto the Motherboard armor, Still need to make a hole for the CPU. but still not sure what CPU block will be used.

Hope you can see where I'm going with what I have done so far.

Thanks for stopping by. 🙂


















Below is the Ai layout for the CNC.



Lots more still to come. 🙂

Thanks again for stopping by.

Cheers, Ken.