04-28-2012
05:18 AM
- last edited on
03-05-2024
10:55 PM
by
ROGBot
04-28-2012 02:03 PM
04-30-2012 09:46 AM
hill01 wrote:
I'm in the same situation - For me the Voltage Slider is stuck at a maximum of 1060 mV:
Also Using CCC 12.4 and Asus GPU Tweak 2.0.8.3. I tried earlier versions (2.0.7.7. and 2.0.5.3) as well, but they can't even read the gpu voltage of the card.
04-30-2012 10:52 AM
05-02-2012 04:22 AM
hill01 wrote:
Apparently Sapphire TRIXX version 4.3.0 can set the gpu voltage on my card beyond 1.060 V - however when I try to overclock I still can't get past 1100 MHz even when raising the voltage massively. Therefore I'm not sure if TRIXX actualy sets any voltages.
05-02-2012 03:54 PM
05-03-2012 03:02 AM
05-03-2012 04:31 AM
hill01 wrote:
There is also this thread
http://www.overclock.net/t/1248620/gpu-tweak-voltage-control-limit
on another forum with some other guy who has the same problem as we do and the already got an answer from Asus, basically saying "screw you if wanna go past this fantastically low value which is far below any dangerous voltage. However if you want to set higher voltages use other tools" - so yeah, I bet many other manufacturers are only happy to include the design and control of an asus custom pcb and VRMs into their program code. Still, if you get a better response, share it. I emailed Asus as well, but didn't get a reply yet.
HiVizMan wrote:
Just click on the image of the lock and it will allow you to independently move the two sliders.
I assume you have enabled the advanced toggle bottom left hand side 🙂
Sorry guys but I do not have a DCII to test actually do not have any ASUS graphic cards of the seven series at all so a bit stuck.
As to official ASUS representation on this forum. There are a couple of guys who work for ASUS motherboards who are here but none from the graphic card side of things. The official ASUS staff all have the @ASUS after their names. The rest of us are just normal folks like you who visit here and help out other users. 🙂
05-03-2012 04:55 AM
05-08-2012 06:38 AM