Assembled new PC. Custom loop with EK active backplate etc. But Only one of my RAM modules show up in Aura-sync (Armoury crate). Is there some setting needed to able sync it too?
The kit is: G.Skill Trident Z5 RGB DDR5-6000 BK C36 DC - 32GB F5-6000J3636F16GX2-TZ5RK
BIOS version 1003
But this did not resolve my issue. The RGB for module installed in B2 slot still remains static. Even the G-skill software can't control it, or even turn the leds off. It just stays as in the pic, a mix of green and yellow, some red.. The module in A2 slot works as expected. Guess I'll swap the sticks install location and see what the result is.. I did initially boot the system with only one module installed, should not be a issue but you never know. Any BIOS settings have effect on this? Remember some earlier motherboards had some in there which had effect on RGB. Other than that the module works, XMP on, 1.4V voltage and runs with memory tester up to 70Ã‚Â°C without errors
There might be some useful info here, the top part not so much, more interesting scroll a page or two. https://www.onecomputerguy.com/g-skill-trident-z-rgb-software-not-working