ill use this thread to collect some new test bioses for the boards, maybe also to explain some less understood options
to disable cores ccd go here and choose ccd xx bit map down core.
each ones stand for an enabled core
best to disable from the back, ie:
110000
instead of 0011000
after selection press downcore apply changes or discard if made mistake
ocpak/octools
FAQ:
7950x not boosting pass 5.5G -> check that CStates is not disabled
Detailed Explanation on CState Boot Limiter
Test BIOSes:
Spoiler
new:
X3D OC Preset for those MB with asynch BCLK Support: (for simple slight perf boost for X3D)
DOCP/EXPO Tweaked: (for simple timings tightening)
strixe-e 1515
for crosshair and strix e-e:
explanation of segment2 Loadline:
customize a heterogenous loadline for a dual segment workload range.
example above shows loadline=L6 when current is in range of 0~40A, and Level4 when current is above 40A.
Adds for x3d
dynamic ccd priority switch with core flex, os / driver agnostic so win10 win11 ok
Algo as follows:
If condition reached and ccd0 specified, then check current mem/cache activity > threshold and hysteresis reached, if fulfilled then switch
If condition reached and ccd1 specified, then check current mem/cache activity <=threshold and hysteresis reached,, if fulfilled then switch
Default hysteresis =4
Can combine multiple algos for ccd priority so combinations are wide
works on non x3d too but of course senseless on it. detailed explanation here.
With the heat and low air humidity, it was necessary to change the curve optimizer value higher, from negative 30 to 15 on all cores. Then I lowered the vSoC and Memory Controller voltage again (by BIOS to 1.390v)
ROG CROSSHAIR/STRIX/PROART X670E/B650 Series Beta Bios 2101 2801
1) Update AGESA to AMD ComboAM5 1180
dont use older cmo file
ROG CROSSHAIR X670E HERO BETA BIOS 2101
https://drive.google.com/file/d/1_CblL0yXtRWUnC__mIbV184_d_Y0jDOJ/view?usp=sharing
ROG CROSSHAIR X670E GENE BETA BIOS 2101
https://drive.google.com/file/d/1QALECkpcG4ZAGI7T5jW3W_j5SkoPQ9iE/view?usp=sharing
ROG CROSSHAIR X670E EXTREME BETA BIOS 2101
https://drive.google.com/file/d/10XlYp9XyKlfK2PxP32LuI736DjSzK0Bd/view?usp=sharing
ROG STRIX X670E-A GAMING WIFI BETA BIOS 2101
https://drive.google.com/file/d/1lIshuOcxQkndpN5oG6N4QilxP7IDJ1rV/view?usp=sharing
ROG STRIX X670E-E GAMING WIFI BETA BIOS 2101
https://drive.google.com/file/d/1uUpILXZzTuOoc1PIY6Ib6JATJLN9oWEK/view?usp=sharing
ROG STRIX X670E-F GAMING WIFI BETA BIOS 2101
https://drive.google.com/file/d/15XOsTmkDXOmvu1KQNHtDwBCQ9UfkNHTC/view?usp=sharing
ROG STRIX X670E-I GAMING WIFI BETA BIOS 2801
https://drive.google.com/file/d/14ceapWIum_o3bQVSAfmhjRIb7V8fOMtg/view?usp=sharing
PROART X670E CREATOR WIFI BETA BIOS 2101
https://drive.google.com/file/d/1EzAUVLj7hEZIpLmh6FLXUxH3649kTFXM/view?usp=sharing
ROG STRIX B650-A GAMING WIFI Beta Bios 2801
https://drive.google.com/file/d/1VABokMafRCVhpvc_E_X7LnC4aSGs0rvG/view?usp=sharing
ROG STRIX B650E-E GAMING WIFI Beta Bios 2801
https://drive.google.com/file/d/1UyZoCOQ72ZEzCUjwdImaj3Lkmi5yb3LH/view?usp=sharing
ROG STRIX B650E-F GAMING WIFI Beta Bios 2801
https://drive.google.com/file/d/1aiwpNQft1MhYscayLuEsMIex-pfVr1pC/view?usp=sharing
ROG STRIX B650E-I GAMING WIFI Beta Bios 2801
https://drive.google.com/file/d/1LR299mJLHJdGCt6EolmEGm9jh6DNGAxF/view?usp=sharing
PROART B650-CREATOR Beta Bios 2101
https://drive.google.com/file/d/1RGqMtuAkfmHyXxskwYkBz7znQSFxKo-s/view?usp=sharing
On my X670E Extreme unless I set the SOC much lower, with the same settings as 1905, I get a double boot and RAM is stuck at 5200 until I set defaults, reboot, and load my saved profile.
And with the lower VSOC my 1905 BIOS settings below very unstable.
