10-04-2022 06:30 AM - edited 10-18-2023 07:20 AM
ill use this thread to collect some new test bioses for the boards, maybe also to explain some less understood options
to disable cores ccd go here and choose ccd xx bit map down core.
each ones stand for an enabled core
best to disable from the back, ie:
110000
instead of 0011000
after selection press downcore apply changes or discard if made mistake
ocpak/octools
FAQ:
7950x not boosting pass 5.5G -> check that CStates is not disabled
Detailed Explanation on CState Boot Limiter
Test BIOSes:
new:
X3D OC Preset for those MB with asynch BCLK Support: (for simple slight perf boost for X3D)
DOCP/EXPO Tweaked: (for simple timings tightening)
strixe-e 1515
for crosshair and strix e-e:
explanation of segment2 Loadline:
customize a heterogenous loadline for a dual segment workload range.
example above shows loadline=L6 when current is in range of 0~40A, and Level4 when current is above 40A.
Adds for x3d
dynamic ccd priority switch with core flex, os / driver agnostic so win10 win11 ok
Algo as follows:
If condition reached and ccd0 specified, then check current mem/cache activity > threshold and hysteresis reached, if fulfilled then switch
If condition reached and ccd1 specified, then check current mem/cache activity <=threshold and hysteresis reached,, if fulfilled then switch
Default hysteresis =4
Can combine multiple algos for ccd priority so combinations are wide
works on non x3d too but of course senseless on it. detailed explanation here.
Solved! Go to Solution.
02-28-2023 04:05 PM
02-28-2023 06:42 PM
ekarren wrote:
All users that have upgraded to 0922 and had a smooth experience, did you have the newest v5 chipset drivers installed before updating?
02-28-2023 07:50 PM
ekarren wrote:
All users that have upgraded to 0922 and had a smooth experience, did you have the newest v5 chipset drivers installed before updating?
02-28-2023 08:10 PM
02-28-2023 09:35 PM
03-01-2023 03:14 AM
03-01-2023 06:21 AM
MagicHp wrote:
Hum, Eco mode, no Bios modification...
It seems the only people that don't have issues are those that "gimp" their system with eco mode or reduced frequencies/voltages or that don't touch settings in the Bios.
Hard to tell, we would need to post our full specs and full settings to compare effectively.... But this doesn't make sense, anyone managed to get ahold of an Asus rep to have some answer? There are several posts on the Asus Reddit about it but I don't think any "official" responded yet.
03-01-2023 06:41 AM
03-01-2023 06:49 AM
MagicHp wrote:
Hum, Eco mode, no Bios modification...
It seems the only people that don't have issues are those that "gimp" their system with eco mode or reduced frequencies/voltages or that don't touch settings in the Bios.
03-01-2023 07:17 AM