Hey guys and ladys!
Sorry for my bad English, i am from Germany. 🙂
My problem is:
Ive buy the C6H with an 1800x 6 weeks ago. But i have some unspecific problems with my rig.
I have 2 Waterpumps on ChaFan 2 and 3, one is for the CPU and for my GPU.
Sometimes one of them speed up and goes near 100% and stand there, sometimes the Pump shuts Down and wont speed up if the CPU heat increase. I have severval Temp-Shutdowns because of it. -.-
Sometimes the other Pump shut off and my GPU reaches 90°C and more, till shutdown.
Sometimes the Sensors are show Both Pumps @ 0rpm, but they still running but stuck at a fix speed.
The Pumps are in the Q-Fan set @ CPU, ive tried to set one @ CPU and one @ another sensor. But no difference.
The other Problem is, sometimes the CPU, Mobo and a few other sensors tell me, that the Temps are @ -79°C and -109°C.
If this happens, the thermal shutdown doenst work.
After a restart everything seems to be well, but after sometimes a few minutes or a few hours, the problems, sometimes all of them, sometimes just a few or only one come back.
At this moment, my CPU Pump runs @ 100%. nearly 20 minutes after restart. Before the restart, one Pump stands randomly on 0% and the cpu reaches 90°C -.-
Ive read the Sensors with AIDA64 and HWINFO. (Both are up to date)
In the Fan-Setting ive set it to silent.
What ive tried:
Flash Bios to 6001
Rollback to 3502
Plug the Pumps on other Ports
Manual Fan profiles
Run @ Optimized Defaults
Edit 19.03.18 3 pm CET:
After rollback to Bios 3502, the problem look a bit different.
After 20-30 minutes Runtime (mostly Idle), the CPU, CPU Socket, Mobo, and some other Sensors of the C6H Temp Stucks @ 25 & 26°C.
And now one of the Pumps, cant be read but is still running.
2nd Edit 19.03.18 5 pm CET:
Ive Plug One Pump in the CPU-Fan port. Since 95 mins, no Tempfails, but 60 minutes after start, BOTH pumps are raised to 60% rpm.
Ive run the q-fan tuning and it sets both to 38%. ^^
The Other Sensors like those inside the CPU or Graphic are Okay. -.-
At this moment, i have load the 3502 Bios and run everything in Stocksettings after CMOS reset (Battery out for 10 minutes).
Just the Fanprofiles, Slow Boot Disabled, Fullscreen Logo off and AHCI -> Raid ist different to the Defaults.
3rd Edit 19.03.18 9 pm CET:
After 2 Hours GTA V, the CPU says in AIDA64 -20°C and in HWINFO it is gone, it shows no CPU Temp @ the ITE IT8665E, AMD Ryzen Enhanced Sensors are work... but both Pumps are Still running. At their minimum RPM, but they run. ^^
4th Edit 20.03.18 - 6:25 pm CET:
The CPU Pump shuts down while i was a half hour Away. The PC Freezed because of Temp-Shutdown. -.-
5th Edit 20.03.18 8 PM CET
Ive plug both pumps on to a manual Fan-controller. Now the board can show arctic and temps of the pluto how much it want. But it will get an RMA. Or someone of you guys, can help. ^^
Thanks for reading and for your help!
Ps: Ive take some screenshots of it.