Can anyone else access the support page to download drivers? Mine flashes on the page and then redirects to the product page with no way to get to bios or driver downloads. I have tried edge as well, different mobo models as well as logging in through my account and clicking on my registered product driver downloads. They all immediately redirect to the product page lol.
I'm having new POST issues with 2803 that I was not encountering previously on 2423. I did not have a single problem on 2423 but upgraded to 2803 as recommended with Windows 11. I was able to adjust my timings down from DOCP of 3600CL18 to 3600CL16 with no issues on 2423. That same stable configuration fails to POST on 2803.
I have settled with using DOCP (XMP/AMP) for the time being, but have encountered another issue. As long as my RAM is set to any profile other than stock / auto, it will fail to POST on a fresh power on. This includes warm(?) boot (shutting down windows and leaving it for a few minutes). Restarts work fine. The Q-CODE shows 01 and the DRAM LED stays on. If I hard shutdown by pressing and holding the power button in this state and turn it back on immediately, it will boot fine. Note that this is a different code to the other boot issues everyone is experiencing of "0D". This never happened on 2423.
I have tried resetting CMOS to no success. I tried slightly increasing DRAM voltage to no success (within recommended limits for my memory). Does anyone have any suggestions? Has anyone else encountered this issue?
I'm using with the B550-F gaming (non-wifi), and no problems to report.
This BIOS version provides the PBO2 option for 5800x3d CPUs (running -30mV all cores and it is stable).
5800x3D - 4x8GB 3200MHz CL-14 (running @ 2933MHz since 4x1R is the supported frequency for this CPU)