ROG CROSSHAIR VIII HERO (WI-FI) X570 and F4-3600C16Q-64GTZNC ISSUES

[TrueWarrior]

I recently purchased a set of F4-3600C16Q-64GTZNC RAM sticks, and after installing them, my PC won't boot. It diaplays an "0d" post code and just stays that way.

What should I do to fix this?

I've tried the following already:

1. Clearing CMOS

2. Turning on DOCP

3. Trying 1 stick at a time in slot A2

Any help would be greatly appreciated. 

[AgCN3]

Power off, press and hold the "Clear CMOS" button on the IO panel of your Motherboard for 5 seconds, and then power up, wait until it posts, and then press Delete or F1 and go into the bios and adjust your settings accordingly.

Hopefully that will work for you.

[knt]

What RAM did you have before?

Might be your setup cannot run the RAM at the specified DOCP setting.

Try manual input of the RAM specification i.e 3600Mhz, timings and voltage.

If that doesn't work,manual input RAM specification to 3200Mhz with the same timings as 3600Mhz and voltage.